6v Driver for 5m EL Wire



  • 6v water resistant driver which will make up to 5 meters of EL wire or 120 square centimetres of EL panel or EL tape glow.
  • Supplied with two crocodile clips attached. These can be cut off if you want to wire this directly into your own 6v source.


In stock

SKU: 6V_0/5m_WR Category:


Here is a 6v water resistant EL Driver that will run up to 5 meters of EL neon glow wire or 120 square centimetres of EL panel or EL tape. The Driver can wired directly into your own 6v power supply.

The driver DOES NOT have an on/off switch or a flashing function

But does have two integral screw fixing points on either side of it so it can be fastened down

It has a water-tight seal all round it including where the wires come in and out of it. Attached in a sensible place it should withstand all types of weather


29mm x 24mm x 19mm

The screw fixing tabs stick out 6mm each on the 29mm side and could easily be cut off


*All the EL wire we supply comes with a connector, so they plug straight into the driver*

The standard EL wire connector making it able to quickly switch between different coloured wire or add a splitter and have several strands of wire – simply clip it in and out the connector

This driver can also run many strands and colours of EL wire as long as the total length of wire is 5 meters or under

– – – – – – – – – – – –

el wire and el tape

EL wire has loads of uses

It looks amazing when decorating the interior or exterior of cars, can be used inside and outside houses and can even be threaded into clothes and hats

It is a cliché to say you are only limited by your imagination but with EL wire it is true!!!

If you have not seen it before it is like a really long glow stick that lasts around 5,000 hours

We’re sure you will be amazed – feel free to message me with any questions

You may also like…