Portable Adjustable Sequencer Driver for 3m EL Wire

£12.00

 

  • Will make up to 3 metres of standard EL Wire or up to 150 sq cm of EL panel or EL tape glow.
  • Features a mode button to select between Sequencer / Continuous On / Off.
  • Supplied with 3 outputs which sequence just one pattern.
  • Control the speed of this pattern from the slowest (0.7sec) right up until the wires are strobing so fast they appear constant.

In stock

Description

This is a really neat little EL Driver/Sequencer

It is about the same size as a standard EL Driver for 3m of EL Wire (9cm x 3cm x 2.5cm) but it has 3 outputs which sequence just one pattern:

Here it is when there is a 2 way splitter on each of the outputs:

adjustable mini sequencer

There is a dial on the side which lets you adjust the speed of this pattern from the slowest (0.7sec) right up until the wires are strobing so fast they appear constant.

The mode button also allows the EL Wires to be on constantly if you prefer

adjustable wheel and mode button on mini el sequencer

It has a mode button to select between : Sequencer – Continuous On – Off

This speed controlled sequencer is capable of powering 3m of EL Wire or up to 150 sq cm of EL Panel

el wire and el tape

– – – – – – – – – – – –

The el wire comes with a standard connector so simply plugs into any EL driver – this makes it easy to change between coloured wire on one driver

by using splitters you can also connect different strands to the same driver

EL wire has loads of uses

It looks amazing when decorating the interior or exterior of cars, can be used inside and outside houses and can even be threaded into clothes and hats

This wire can be cut into smaller lengths and attached to another driver

Our drivers can run many strips of wire as long as the total length of the wire is under the driver’s maximum capacity

It is easier to buy it from us with the connectors attached but if you need to, then with some care, the EL wire can be attached to speaker wire to make patterns or extend the wire over gaps where it isn’t needed

Joining tape and tubing for attaching EL Wire is available from our online store.
This is if you want to cut the EL wire and rejoin it or perhaps attach some wire to a different driver

Cutting the wire into the length you choose is simple… but rejoining it takes care and attention.

You will also definitely need some wire strippers

It is also recommended placing this joint away from where is likely to encounter stress (e.g. if it is threaded into clothes that will then be bent and jostled – try to keep this joint out for harms way – e.g. avoid putting it at the elbows)

It is a cliché to say you are only limited by your imagination but with EL wire it is true!!!

If you have not seen it before it is like a really long glow stick that lasts over 5,000 hours

We’re sure you will be amazed – feel free to message us with any questions.

You may also like…