Adjustable Motion Sensor (12v) 2.1mm/5.5mm 12v Input



  • This is a PIR (passive infra-red) sensor with a 110 degree detection angle.
  • Adjustable between 30 seconds and 10 minutes.
  • Ready to plug in between any power supply and any 12v adaptable driver, with a 5.5mm/2.1mm jack plug.
  • Can be used with a range of power supplies from mains, to batteries, to direct 12v connection etc.

In stock


This in-line Adjustable Motion Sensor sits between the power output and a driver allowing you to control your EL Panels, Tapes, Wires and LED’s with motion.

This Motion Sensor comes ready to plug in with 5.5mm/2.1mm jack plug

This is a PIR (Passive Infra-red) sensor and has 110 degree angle and is adjustable between 30 seconds and 10 minutes

input/output from 12v to 24v

the sensor is 3.5cm diameter with both leads being 50cm long and ending in 5.5mm/2.1mm jack plug


LED inline infra-red motion sensor

This In-line Motion Sensor will plug in between any power supply below and a 12v adaptable driver


2) Crocodile Clips

crocodile clips

Perfect if you already have your own 12V battery to run a driver


3) 8xAA Battery Box


This 8xAA Battery Box will plug straight into the driver. It is fairly large (63mm X 58mm X 30mm) but will make an EL Driver portable


4) 3 x 18650 Rechargeable Battery Box


This 3 x 18650 Rechargeable Battery Box will plug straight into the driver. It is fairly large (63mm X 58mm X 30mm) and the leads for the output are 15cm long but will make an EL Driver portable.


5) Rechargeable Li-ion Battery

rechargable li-ion battery

Much smaller and lighter than the Battery Box, these powerful Li-ion batteries come in a range of sizes

1800mAh (thin): 125g (10cm x 5.5cm x 0.8cm)

1800mAh (square): 125g (5cm x 3.3cm x 2.7cm)

3000mAh: 172g (7.3cm x 5.6cm x 2.2cm)

5000mAh: 250g (5.3cm x 5.8cm x 3.9cm)

All of these Li-ion Batteries come with an intelligent recharger

(Li-ion Batteries are only available to the UK due to airmail postal restrictions)

6) Mains Powered

mains PSU for EL Wire

This handy PSU can be used to make any EL Driver powered off of Mains Electricity (UK, US or Euro plugs are available)


9) Car Lighter Adaptor

This adaptor plugs into the car lighter socket. It is fused and ends with a 5.5mm/2.1mm jack plug so it can be used with any of our 12v Drivers or Accessories


Most people also use Splitters that come from the Driver to the EL Wire (so you only need 1 x Driver for many EL Wires) – you can get those types of EL WIRE SPLITTERS HERE


*If you want more than one of the power connector mentioned above for your EL Driver,

They can all be found in our Accessories section, or just click the description you want and be taken to its own page*

*All the EL wire we supply comes with a connector, so they plug straight into the driver*

– – – – – – – – – – – –

el wire and el tape

EL wire has loads of uses

This neon wire looks amazing when decorating the interior or exterior of cars, can be used inside and outside houses and can even be threaded into clothes and hats

It is a cliché to say you are only limited by your imagination but with EL wire it is true!!!

If you have not seen it before it is like a really long glow stick that lasts over 5,000 hours

We’re sure you will be amazed – feel free to message us with any questions.